Select all that apply Form is gives the object this look?
a. Flat
b. Textured
c. Dark
D. 3d

Simon says is a memory game where "simon" outputs a sequence of 10 characters (r, g, b, y) and the user must repeat the sequence. create a for loop that compares the two strings starting from index 0. for each match, add one point to userscore. upon a mismatch, exit the loop using a break statement. assume simonpattern and userpattern are always the same length. ex: the following patterns yield a userscore of 4: simonpattern: rrgbryybgy userpattern: rrgbbrybgy

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

Joe needs to see the slide transitions and animations he has applied to his slides in a large view. which presentation view should he use? in which tab would joe find the animations option to make further changes, if any?