subject

If there is no forwarding and hazard detection unit, insert nops in the code to ensure correct operation. How many clock cycles are needed to finish this set of instructions?.

ansver
Answers: 3

Another question on Computers and Technology

question
Computers and Technology, 22.06.2019 08:10
Technician a says that if a valve is open when a piston rises to the very top of a cylinder, the piston may actually strike the valve head and cause serious engine damage. technician b says if the camshaft is located in the engine block, then the engine is called an overhead valve engine, ohv engine, or an in-block camshaft. who is right? a. b only b. both a and b c. a only d. neither a nor b
Answers: 3
question
Computers and Technology, 23.06.2019 19:00
Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."
Answers: 1
question
Computers and Technology, 23.06.2019 20:00
Me ajude por favor , coloquei uma senha e nĂŁo consigo tira-la no chorme
Answers: 2
question
Computers and Technology, 24.06.2019 17:40
Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately
Answers: 2
You know the right answer?
If there is no forwarding and hazard detection unit, insert nops in the code to ensure correct opera...
Questions
question
Social Studies, 03.03.2021 19:20
question
Mathematics, 03.03.2021 19:20
question
Advanced Placement (AP), 03.03.2021 19:20
question
History, 03.03.2021 19:20
question
Mathematics, 03.03.2021 19:20
question
Mathematics, 03.03.2021 19:20
question
Mathematics, 03.03.2021 19:20
question
Mathematics, 03.03.2021 19:20