Write a pseudo code to request for four number Display the sum of the four number,
Display the difference between the summation of the first two and last two
number
Display the average of the numbers.

3. (6 pts) internally in the computer, with few exceptions, all numerical computation is done using binary numbers. output, however, often uses ascii, which is formed by appending 011 to the left of a bcd code. thus, an algorithm that directly converts a binary integer to a bcd integer is very useful. here is one such algorithm 1) draw lines to the left of the binary number to bound the expected bcd decades. (each decade is a group of 4 bits.) move the binary number one bit to the left. add 0011 to each bcd decade containing a binary value> 0100 repeat steps 2-3 until the last bit in the binary number has been moved into the least significant decade position. (note that when the last bit has been shifted into bcd decade, step 3 is not repeated.) read the bcd result. 2) 3) 4) 5) a) execute the algorithm for the binary number 1101101 b) execute the algorithm for the binary number 01110101110 4. (4 pts) represent the decimal number 3568 in bcd; excess-3 code; ascil; and hex.

When jen is planning to upgrade to a monitor with a better resolution, what should she be looking for in the new monitor?

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)