Write Prolog clauses for a member predicate: member(X, L) succeeds if X is a member of the list L. Draw search trees of sub-goals to explain the operation of your code. g

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

After you clean an engine with hot water spray, it seems to stall; when it doesn't stall, it's idling noisily. technician a says to check for loose bolts on the flex plate near the torque converter. technician b says to wipe down the spark plug wires and the distributor cap. who is correct? a. technician a b. both technicians a and b c. technician b

Write a method that takes in an array of point2d objects, and then analyzes the dataset to find points that are close together. be sure to review the point2d api. in your method, if the distance between any pair of points is less than 10, display the distance and the (x,y)s of each point. for example, "the distance between (3,5) and (8,9) is 6.40312." the complete api for the point2d adt may be viewed at ~pf/sedgewick-wayne/algs4/documentation/point2d.html (links to an external site.)links to an external site.. try to write your program directly from the api - do not review the adt's source code.