5.11 LAB: User-Defined Functions: Driving cost Define a function named DrivingCost with parameters drivenMiles, milesPerGallon, and dollarsPerGallon, that returns the dollar cost to drive those miles. All items are of type float. Ex: If the function is called with: 50 20.0 3.1599 the function returns: 7.89975 Write a main program whose inputs are the car's miles/gallon and the gas dollars/gallon (both floats). Output the gas cost for 10 miles, 50 miles, and 400 miles, by calling function DrivingCost() three times. Output the cost with two digits after the decimal point, which can be achieved as follows: Put cost to output with 2 decimal places Ex: If the input is: 20.0 3.1599 the output is: 1.58 7.90 63.20 Note: Small expression differences can yield small floating-point output differences due to computer rounding. Ex: (a b)/3.0 is the same as a/3.0 b/3.0 but output may differ slightly. Because our system tests programs by comparing output, please obey the following when writing your expression for this problem. In the DrivingCost function, use the variables in the following order to calculate the cost: drivenMiles, milesPerGallon, dollarsPerGallon.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."