Computers and Technology, 16.08.2021 14:00 amcalfie

Why do we need on output device?

Answers: 2

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 11:00

The editing of digital photos us about the same level of difficulty as editing an analog photo

Answers: 2

Answer

Computers and Technology, 22.06.2019 19:30

Singing in the rain: this first part of the film shows the early history of motion picture. how accurate do you think the portrayal of the early motion picture industry is? why? is historical accuracy important in films and theater productions? explain.

Answers: 1

Answer

Computers and Technology, 22.06.2019 22:00

Researchers measured the data speeds for a particular smartphone carrier at 50 airports. the highest speed measured was 78.1 mbps. the complete list of 50 data speeds has a mean of x overbarequals16.11 mbps and a standard deviation of sequals18.65 mbps. a. what is the difference between carrier's highest data speed and the mean of all 50 data speeds? b. how many standard deviations is that [the difference found in part (a)]? c. convert the carrier's highest data speed to a z score. d. if we consider data speeds that convert to z scores between minus2 and 2 to be neither significantly low nor significantly high, is the carrier's highest data speed significant? a. the difference is nothing mbps.

Answers: 3

Answer

Computers and Technology, 23.06.2019 15:30

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to