Falcon 3D cuboids extended range intro course POP QUIZ! What is true about RADAR points? 1. They look like lines with dots 2. You should never clip them 3.Radar points show exact points of objects 4.Radar points show general points of objects 5.Press R to see RADAR points 6.Every object you annotate must at least have 1 Radar point 7.They will be especially important for objects far away 8.They will be especially important for objects close by

Which of the following is true of operations within a spreadsheet program’s built-in functions? a. operations within parentheses, then multiplication and division, and then addition and subtraction are computed. b. operations within parentheses, then addition and subtraction, and then multiplication and division are computed. c. multiplication and division, then addition and subtraction, and then operations within parentheses are computed. d. addition and subtraction, then multiplication and division, and then operations within parentheses are computed

[a] create a class called “cycle” which has two instance integer variables as properties, “numberofwheels” and “weight.” create a constructor with two parameters, using the same variable names in the parameter list. assign each variable to numberofwheels” and “weight” respectively. write a separate application to test the class and display its properties. note: do not change the names of the instance variables or the variables listed in the constructor’s parameter list. [b] edit your class cycle by adding a default constructor which will assign the default values of 100 to represent the numberofwheels, and 1000 to represent the weight, by invoking a call to the other constructor. modify your application created in [a] to test the class.

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it