9. Which of the following best describes the purpose of an IP address? A. IP addresses provide a unique number for identifying devices that send and receive information on the Internet
B. IP addresses assist in the reconstruction of a message that has been divided into many packets
C. IP addresses indicate the location where an internet-connected computing device was manufactured
D. IP addresses indicate how many times an individual packet has been requested by a router

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t

How does a policy manual an organization? a. it boost productivity. b. it create awareness in employees about the organization’s values. c. it employees achieve targets. d. it safeguards the organization from liabilities.

Write a new lc-3 trap subroutine (i.e. a subroutine that will be invoked via the trap instruction) that will receive a numeric digit entered at the keyboard (i.e. an ascii character), echo it to the screen, and return in r0 the corresponding numeric value: so if the user types the digit '7', the character '7' will appear on the screen, but the value returned in r0 will be b0000 0000 0000 0111 (#7) you may not use any trap calls in your code - you must implement the "polling" code that interrogates the keyboard status and data registers. ; getnum_tsr ; a subroutine for obtaining a numeric value ; given ascii numeric digit input to keyboard. ; the numeric digit is echoed to the console (e.g. '7' = b0000 0000 0011 0111), ; but the value returned in r0 is the actual numeric value ; corresponding to the digit (e.g. b0000 0000 0000 0111 =