Compare and contrast the "synthesis of a problem" phase with the "draw a conclusion" phase of the scientific method.

Problems: 1. using textbooks, reference books, and internet as your source of research, draw the following microprocessor microarchitectures i. intel 8086 ii. motorola 68000 i atmel atmega32 iv. mips single cycle v. arm cortex-m3 write an hdl module for a hexadecimal seven-segment display decoder. the input is 4-bit binary representing a hex number (0-f), and the output is 8-bit seven segment display bits (a-h). thus, the decoder must handle the digits 10 - 15 to display a-f respectively, in addition to 0-9 numbers. 2. design a 4-bit left and right rotator (both outputs). first sketch schematic diagrams of your design. then implement your design using hdl coding. 3. 4. design a modified priority encoder that receives an 8-bit input, a7: 0 and produces a 3-bit output, y2o. y indicates the most significant bit of the input that is true. y should be 0 if none of the inputs are true. give a simplified boolean equation, sketch a schematic, and write an hdl code. 5.write an 8: 1 multiplexer module called mux8 with selection inputs s, data input d, and data output y. data input (d) and data output (v) are 32-bit wide

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Asample of 200 rom computer chips was selected on each of 30 consecutive days, and the number of nonconforming chips on each day was as follows: 8, 19, 27, 17, 38, 18, 4, 27, 9, 22, 30, 17, 14, 23, 15, 14, 12, 20, 13, 18, 14, 20, 9, 27, 30, 13, 10, 19, 12, 26. construct a p chart and examine it for any out-of-control points. (round your answers to four decimal places.)