Computers and Technology, 14.04.2020 22:21 Bearboy1564

Consider a router that interconnects four subnets: S1, S2, S3, and S4. Suppose all of the interfaces in each of these four subnets are required to have the prefix 199.100.8.0/21. You want to divide this address block into four equal-sized contiguous address blocks, and give one of these address blocks to each subnet connected to the router. Provide network addresses (of the form a. b.c. d/x) that satisfy this requirement.

Answers: 1

Show answers

Answers

Answer from: AngelOfLove

S1: 199.100.8.0 /23

S2: 199.100.10.0 /23

S3: 199.100.12.0 /23

S4: 199.100.14.0 /23

Explanation:

199.100.8.0/21 is equivalent to 8 Class C networks. We can prove this by starting to count at /24 provided with its subnet mask:

255.255.255.0 /24 is 1 Class C network

255.255.254.0 /23 is 2 Class C networks.

255.255.252.0 /22 is 4 Class C networks.

255.255.248.0 /21 is 8 Class C networks

(You can see the pattern that whenever the CIDR goes down a bit the Class C network multiples by 2: 1 * 2 * 2 * 2 = 8)

The subnets than you can allocate for /21 is 199.100.8.0, 199.100.9.0, 199.100.10.0, 199.100.11.0, 199.100.12.0 ,199.100.13.0, 199.100.14.0 and 199.100.15.0.

The truth is what s1, s2, s3, and s4 actually needs are four equal-sized contiguous address blocks, so what we possibly will give the 4 subnets are a combination of 2 Class C networks each. So we combine 199.100.8.0 and 199.100.9.0 to one subnet, 199.100.10.0 and 199.100.11.0 one subnet, 199.100.12.0 and 199.100.13.0 to one subnet, and 199.100.14.0 and 199.100.15.0 to one subnet. Equal to 4 subnets.

If that is the case:

S1:

Network Address 199.100.8.0 /23

Subnet Mask = 255.255.254.0

Wild Card Address = 0.0.1.255

Range = 199.100.8.1 to 199.100.9.254

Host = 510

Broadcast Address = 199.100.9.255

S2:

Network Address 199.100.10.0 /23

Subnet Mask = 255.255.254.0

Wild Card Address = 0.0.1.255

Range = 199.100.10.1 to 199.100.11.254

Host = 510

Broadcast Address = 199.100.11.255

S3:

Network Address 199.100.12.0 /23

Subnet Mask = 255.255.254.0

Wild Card Address = 0.0.1.255

Range = 199.100.12.1 to 199.100.13.254

Host = 510

Broadcast Address = 199.100.13.255

S4:

Network Address 199.100.14.0 /23

Subnet Mask = 255.255.254.0

Wild Card Address = 0.0.1.255

Range = 199.100.14.1 to 199.100.15.254

Host = 510

Broadcast Address = 199.100.15.255

Answer from: Quest

Call then make sure to check your email

Answer from: Quest

answer; ( blue box );

Another question on Computers and Technology

Computers and Technology, 22.06.2019 16:50

Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?

Answers: 3

Answer

Computers and Technology, 22.06.2019 19:00

How is the number 110 written when expanded out to place values in the base 2 (binary) number system? options: 2 x 4 + 3 x 2 + 4 x 1 1 x 2 + 1 x 2 + 0 x 2 1 x 100 + 1 x 10 + 0 x 1 1 x 4 + 1 x 2 + 0 x 1

Answers: 1

Answer

Computers and Technology, 23.06.2019 09:30

Write a function called checkfactor that takes two arrays of positive numbers, firstnumberrow and secondnumberrow. checkfactor checks if the first entry in firstnumberrow is divisible by the first entry in secondnumberrow, and performs the same operation on the next array elements until all entries have been checked. all the numbers are positive and the number of entries in the arrays are the same. the function should return the identified divisible numbers in two row arrays named firstdivisible and seconddivisible.restrictions: branches or loops should not be used. the code must use the internal mod and logical functions.hint: the mod function should be used to determine if two numbers are divisible. ex: for num1 and num2 if mod(num1,num2) is 0, then the two numbers are divisible.this is matlab

Answers: 2

Answer

Computers and Technology, 24.06.2019 05:50

What all vehicles has tesla inc. created over the years

Answers: 3

Answer

You know the right answer?

Consider a router that interconnects four subnets: S1, S2, S3, and S4. Suppose all of the interfaces...

Questions