Computers and Technology, 10.03.2020 08:00 eyebang

Consider this data sequence: "3 11 5 5 5 2 4 6 6 7 3 -8". Any value that is the same as the immediately preceding value is considered a CONSECUTIVE DUPLICATE. In this example, there are three such consecutive duplicates: the 2nd and 3rd 5s and the second 6. Note that the last 3 is not a consecutive duplicate because it was preceded by a 7. Write some code that uses a loop to read such a sequence of non-negative integers, terminated by a negative number. When the code finishes executing, the number of consecutive duplicates encountered is printed. In this case,3 would be printed.

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 04:00

Acetylene is a gas which burns rapidly on its own, and is considered highly explosive. a) true b) false

Answers: 2

Answer

Computers and Technology, 23.06.2019 06:00

Which statement is true of web-based social media? a.they allow consumers to interact with and update content. b.they cannot be updated easily, as compared to print media. c.they are expensive to produce and maintain, as compared to print and television. d.they can exist independent of the internet.

Answers: 1

Answer

Computers and Technology, 23.06.2019 07:00

Why were most movies from the late 1890s until the early 1930s only filmed in black and white? there were only a few people who could afford the technology to produce color motion pictures back then. audiences did not want color motion pictures until later. the film used to make color motion pictures often overheated, which was a safety hazard, so it was generally not allowed. color films had to be hand-colored, frame by frame.

Answers: 3

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

You know the right answer?

Consider this data sequence: "3 11 5 5 5 2 4 6 6 7 3 -8". Any value that is the same as the immediat...

Questions