’s law is the mathematical formula that describes belief that the large and powerful computers will always be more cost effective than smaller ones.

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.

We as humans write math expression in infix notation, e.g. 5 + 2 (the operators are written in-between the operands). in a computer’s language, however, it is preferred to have the operators on the right side of the operands, i.e. 5 2 +. for more complex expressions that include parenthesis and multiple operators, a compiler has to convert the expression into postfix first and then evaluate the resulting postfix.write a program that takes an “infix” expression as input, uses stacks to convert it into postfix expression, and finally evaluates it. it must support the following operations: + - / * ^ % (example infix expression: (7 - 3) / (2 + 2)postfix expression: 7 3 - 2 2 + /result: 1guidelines: 1. you will need to use stacks in three placesa. one for the parenthesis check [char stack]b. one during infix to postfix [char stack]c. one during evaluation [int stack]for a and b above, you can use same array and same push, pop method as both ofthem are char. but for evaluation you have int stack and you might consider to createanother push pop method to handle it. maybe push_int, pop_int, etc. or find otherstrategy to utilize existing push pop method2. you can create a function for obtaining operator priority. that function should take anoperator as input and return its priority as an integer. this function will you a lot andreduce repeated code3. during evaluation you will need to convert char into integer. example for single digit: char c = '5'; int x = c - '0';

1. technician a says horsepower information can be used by consumers to compare the power of different automobile engines. technician b says that manufacturers will often list the horsepower output of their engines in the online service information. who is right?