Draw the stack and queue data structures (for both the array and linked list implementations) for each step in the following sequence: add(1), add(2), remove, add(3), add(4), remove, remove, add(5). assume an initial size of 3 for the array implementation.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

You have a small company and want to keep your costs low, but it is important your employees share data. which network would provide you with the most economical solution?

Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system.currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system.currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system.currenttimemillis() just after the end of the algorithm as the elapsed time.