Write an assembly language program to rotate given myarray based on a variable r as follows: r specifies the rotation direction and number of rotations on that direction; positive r indicates rotation in right direction, negative r indicates rotation in the left direction, and r = 0 does nothing. all variables are of type sdword. example: myarray = [1, 2, 3, 4, 5, 6, 7] r = 1(rotate once in right direction in circular fashion) after execution: myrotatedarray = [7, 1, 2, 3, 4, 5, 6] r = 2 (rotate twice in right direction in circular fashion) after execution: myrotatedarray = [6, 7, 1, 2, 3, 4, 5] r= -1 (rotate once in left direction in circular fashion) after execution: myrotatedarray = (2, 3, 4, 5, 6, 7, 1] r= -3 (rotate thrice in left direction in circular fashion) after execution: myrotatedarray = [4, 5, 6, 7, 1, 2, 3] wote: your program should work for arbitrary values of r and arbitrary length array. it also must include data and .code section.

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

The option enables you to modify a slide element in most presentation applications.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."