The insertion sort algorithm sorts using what technique?

Consider this data sequence: "3 11 5 5 5 2 4 6 6 7 3 -8". any value that is the same as the immediately preceding value is considered a consecutive duplicate. in this example, there are three such consecutive duplicates: the 2nd and 3rd 5s and the second 6. note that the last 3 is not a consecutive duplicate because it was preceded by a 7. write some code that uses a loop to read such a sequence of non-negative integers , terminated by a negative number. when the code finishes executing, the number of consecutive duplicates encountered is printed. in this case, 3 would be printed. assume the availability of a variable, stdin, that references a scanner object associated with standard input. that is, stdin = new scanner(system.in); is given.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Why would a programmer use the logical operator and in an if statement? a: when an action is to be taken that requires both conditions to be falseb: when an action is to be taken that requires both conditions to be truec: when an action is to be taken that requires the first condition to be falsed: when an action is to be taken that requires the second condition to be truei took the test and the answer is b.