Computers and Technology, 07.08.2019 00:20 londonchanel

If a binary signal is sent over a 3-khz channel whose signal-to-noise ratio is 20db, what is the maximum achievable data rate? ( analyze based on nyquist theorem and shannon theorem. maximum data rate is limited by the smaller value of nyquist limit and shannon limit. note that, the s/n in shannon equation is just a ratio, not in the unit of ‘db’.)

Answers: 3

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 13:00

Which part of the cpu accepts data?

Answers: 1

Answer

Computers and Technology, 22.06.2019 17:20

[a] create a class called “cycle” which has two instance integer variables as properties, “numberofwheels” and “weight.” create a constructor with two parameters, using the same variable names in the parameter list. assign each variable to numberofwheels” and “weight” respectively. write a separate application to test the class and display its properties. note: do not change the names of the instance variables or the variables listed in the constructor’s parameter list. [b] edit your class cycle by adding a default constructor which will assign the default values of 100 to represent the numberofwheels, and 1000 to represent the weight, by invoking a call to the other constructor. modify your application created in [a] to test the class.

Answers: 3

Answer

Computers and Technology, 23.06.2019 03:30

How can you repin an image on your pinterest pin board a. click on the "repin" button b. click on the "add pin" button c. click on the "upload a pin" button d. click on the "save pin" button.

Answers: 2

Answer

Computers and Technology, 23.06.2019 15:30

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

Answer

You know the right answer?

If a binary signal is sent over a 3-khz channel whose signal-to-noise ratio is 20db, what is the max...

Questions