The danger in using soy solvents is that they: a) are not approved by the fda b) take paint off of surfaces where used c) are not approved by the epa d) do not clean as well as petroleum solvents

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Alook-up table used to convert pixel values to output values on a monitor. essentially, all pixels with a value of 190 or above are shown as white (i.e. 255), and all values with a value of 63 or less are shown as black (i.e. 0). in between the pixels are scaled so that a pixel with a value p is converted to a pixel of value 2/127 −+3969). if a pixel has a value of 170 originally, what value will be used to display the pixel on the monitor? if a value of 110 is used to display the pixel on the monitor, what was the original value of the pixel?

Given int variables k and total that have already been declared, use a while loop to compute the sum of the squares of the first 50 counting numbers, and store this value in total. thus your code should put 11 + 22 + 33 + + 4949 + 50*50 into total. use no variables other than k and total.