Upgrading only the motherboard will give some performance improvement to a computer system. why would the improvement be limited?

Write a program that defines symbolic names for several string literals (chars between quotes). * use each symbolic name in a variable definition. * use of symbolic to compose the assembly code instruction set can perform vara = (vara - varb) + (varc - vard); ensure that variable is in unsigned integer data type. * you should also further enhance your symbolic logic block to to perform expression by introducing addition substitution rule. vara = (vara+varb) - (varc+vard). required: debug the disassembly code and note down the address and memory information.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

Will this setup result in what kathy wants to print?