Chemistry, 05.03.2021 22:10 bella2284

Good scientific models can be tested and use to make predictions. What did Molina and Rowland's model of the interactions of CFCs and ozone in the atmosphere predict would happen to the amount of ozone in the stratosphere as the level of CFCs increased?

Answers: 1

Show answers

Answers

Answer from: Quest

kuchisake

kuchisake-onna (口裂け女, "slit mouth woman ") is a malevolent figure appearing in japanese ghost stories, possibly dating back to the edo period. she takes the form of a masked woman who approaches people and asks them if they believe she is pretty.

explanation:

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

answer: $2c_5h_5+1fe\rightarrow 1fe(c_5h_5)_2$

the reaction is type of combination reaction.

explanation:

$? c_5h_5+? fe\rightarrow ? fe(c_5h_5)_2$

on the product side, there are 2 molecules of $c_5h_5$ bonded to fe which means one atom of fe are combined two molecules of $c_5h_5$ . so, balanced chemical equation becomes :

$2c_5h_5+1fe\rightarrow 1fe(c_5h_5)_2$

this reaction follows the reaction type of combination reaction. a combination reaction is defined as chemical reaction in which reactants combines together to form a single product.

$a+b\rightarrow ab$

Answer from: Quest

your answer is a. the enthalpy of formation for a pure element in its standard state is always positive.

Another question on Chemistry

Chemistry, 22.06.2019 06:30

Identify the missing numbers below to show the result of multiplying the numbers (1.6 × 10-19)(5.0 × 106) = c × 10d

Answers: 1

Answer

Chemistry, 22.06.2019 07:30

In a reaction (at equilibrium) that makes more moles of gas than it consumes, what is the effect of increasing the pressure?

Answers: 1

Answer

Chemistry, 22.06.2019 10:00

In a water molecule, hydrogen and oxygen are held together by a(an) bond. a) double covalent b) ionic c) nonpolar covalent d) hydrogen e) polar covalent

Answers: 1

Answer

Chemistry, 22.06.2019 13:00

Lab reagent, hypothesis test.a reference solution used as a lab reagent is purported to have a concentration of 5 mg/dl. six samples are taken from this solution and the following concentrations are recorded: (5.32, 4.88, 5.10, 4.73, 5.15, 4.75) mg/dl.these six measurements are assumed to be an srs of all possible measurements from solution.they are also assumed to have a standard deviation of 0.2, a normal distributin, and a mean concentration equal to the true concentration of the solution.carry out a significance test to determine whether these six measurements provide reliable evidence that the true concentration of the solution is actually not 5 mg/dl.

Answers: 1

Answer

You know the right answer?

Good scientific models can be tested and use to make predictions. What did Molina and Rowland's mode...

Questions