subject
Chemistry, 30.09.2019 15:00 AshNo

If you can answer all of these you get 50 pts
#1 which is usually associated with a faster reaction rate?
a. adding a catalyst to the reactants
b. blowing a whistle near the reactants
c. removing heat energy from the reactants
d. decreasing the concentration of a solution of the reactants
#2 which is usually associated with a faster reaction rate?
a. adding heat energy to the reactants
b. putting a glass cover over the reactants
c. using a solid with a low surface area in the reactants
d. decreasing the concentration of a solution of the reactants
#3 which is usually associated with a slower reaction rate?
a. adding a catalyst to the reactants
b. using a crushed solid in the reactants
c. using a strong solution of the reactants
d. removing heat energy from the reactants
#4 which is usually associated with a slower reaction rate?
a. ringing a bell near the reactants
b. adding heat energy to the reactants
c. using a weak solution of the reactants
d. using a solid with a high surface area in the reactants
#5 which concentration of hydrochloric acid would most likely react with a zinc metal strip at the fastest rate?
a. 10%
b. 20%
c. 30%
d. 40%
#6 which is usually associated with a faster reaction rate?
a. shaking pepper into the reactants
b. removing heat energy from the reactants
c. using a highly concentrated solution in the reactants
d. using a solid with a low surface area in the reactants
#7 which is usually associated with a slower reaction rate?
a. shaking pepper into the reactants
b. adding heat energy to the reactants
c. using a solid with a low surface area in the reactants
d. using a highly concentrated solution of the reactants

ansver
Answers: 2

Another question on Chemistry

question
Chemistry, 21.06.2019 17:30
The following reaction shows the products when sulfuric acid and aluminum hydroxide react. al(oh)3 + h2so4 → al2(so4)3 + h2o the table shows the calculated amounts of reactants and products when the reaction was conducted in a laboratory. initial mass and yield sulfuric acid aluminum hydroxide initial amount of reactant 40 g 15 g theoretical yield of water from reactant 14.69 g 10.38 g what is the approximate amount of the leftover reactant? 11.73 g of sulfuric acid 10.33 g of sulfuric acid 11.12 g of aluminum hydroxide 13.67 g of aluminum hydroxide
Answers: 1
question
Chemistry, 22.06.2019 05:20
Identify and describe the three ways that mutations affect organisms.
Answers: 1
question
Chemistry, 22.06.2019 07:30
11. phosphorus-32 is radioactive and has a half life of 14 days. how much of a 124 mg sample of phosphorus-32 is present after 56 days? a) 7.75 mg b) 15.5 mg c) 31.0 mg d) 62.0 mg
Answers: 3
question
Chemistry, 22.06.2019 10:50
Someone offer some answers to this, i will give 98 coins and mark as brainliest! i will put the rest of the lab down in the comments,solutions pre-lab questions: in this lab, you will make fruit drinks with powdered drink mix. complete the pre-lab questions to get the values you need for your drink solutions. calculate the molar mass of powered fruit drink mix, made from sucrose (c12h22o11).using stoichiometry, determine the mass of powdered drink mix needed to make a 1.0 m solution of 100 ml. (hint: use molarity = to find the moles of drink mix, then convert moles to grams using a mole conversion.)what mass of powdered drink mix is needed to make a 0.5 m solution of 100 ml?
Answers: 1
You know the right answer?
If you can answer all of these you get 50 pts
#1 which is usually associated with a faster rea...
Questions
question
Biology, 07.02.2021 20:40
question
Physics, 07.02.2021 20:40