Chemistry, 25.01.2021 20:40 mdean858

Experiments were done on a certain pure substance X to determine some of its properties. There's a description of each experiment in the table below. In each case, decide whether the property measured was a chemical or physical property of X, if you can. If you don't have enough information to decide, choose can't decide in the third column. Property P: A small sample of X is dissolved in water. Drops of another solution, containing dissolved sodium hydroxide, are slowly added, and a pH indicator is used to determine when the sodium hydroxide has completely reacted with X. From the amount of sodium hydroxide needed, the value of P may be calculated.
Property D: A sample of X is carefully weighed and put inside a vented flask. Water is added to the flask until it just covers the sample, and the volume of sample and water is recorded. Then the sample is removed and the volume of water alone recorded. From the mass of the sample and the difference in volumes, the value of R may be calculated.
Property V: Sample of X is melted and put into a reservoir from which a very thin tube leads down. The rate at which X flows out of the tube is measured, and from this rate the value of V may be calculated.

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 01:30

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.

Answers: 1

Answer

Chemistry, 22.06.2019 15:30

Using the first volume and temperature reading on the table as v1 and t1, solve for the unknown values in the table below. remember to use the rules of significant figures when entering your numeric response.

Answers: 2

Answer

Chemistry, 22.06.2019 18:40

What is the binding energy of a nucleus that has a mass defect of 5.81*10-^29 kg a 5.23*10-^12 j b 3.15* 10^12 j c 1.57*10-3 j d 9.44*10^20 j

Answers: 1

Answer

Chemistry, 22.06.2019 20:10

Insoluble sulfide compounds are generally black in color. which of the following combinations could yield a black precipitate? check all that apply. na2s(aq)+kcl(aq) li2s(aq)+pb(no3)2(aq) pb(clo3)2(aq)+nano3(aq) agno3(aq)+kcl(aq) k2s(aq)+sn(no3)4(aq)

Answers: 1

Answer

You know the right answer?

Experiments were done on a certain pure substance X to determine some of its properties. There's a d...

Questions

Chemistry, 27.03.2020 00:04

The equation below shows hydrogen reacting with oxygen to produce water. 2H2 + O2 Right arrow. 2H2O If 16 mol of oxygen were r...