In an acid-base titration, how would you monitor the progress of the experiment and know when it was completed? A. Continue the reaction until you have added an equal volume of acid to the base.
B. Add 1 ml of acid at a time to the base and monitor with pH paper until it is neutral.
C. Use indicator solution which changes color when enough acid is added to react with all the base.
D. Place a thermometer in the flask and continue adding acid until a temperature change is noted.

most likely he is cheating on you

out of these options:

ability to burn paper

pure sodium reacting violently with water

the boiling point of water

helium does not tend to react with anything

i would say this is a physical property:

helium does not tend to react with anything

why? :

i said helium does not tend to react with anything because well, it reacts to ! but ability to burn paper, pure sodium reacting violently with water, & the boiling point of water are chemical or

physical properties: the properties of a substance that can be observed without changing the chemical makeup of the substance

chemical properties: properties of a substance relating to the chemical nature and reactivity of the substance

atomic number of carbon is 6

electronic configuration of carbon is 1s²2s²2p²

orbital diagram of carbon is as shown here in the image.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.