subject
Chemistry, 25.03.2020 21:10 tdahna0403

1. Stirring increases the rate of solution
by increasing the rate of between
the solvent and the solute.
A. Collision
B. Evaporation
C. Sublimation

2 A hot solvent helps a solid dissolve faster because an increase in that also increases the rate of collisions

ansver
Answers: 3

Another question on Chemistry

question
Chemistry, 21.06.2019 21:00
Harvey kept a balloon with a volume of 348 milliliters at 25.0Ėšc inside a freezer for a night.  when he took it out, its new volume was 322 milliliters, but its pressure was the same.  if the final temperature of the balloon is the same as the freezerā€™s, what is the temperature of the freezer? the temperature of the freezer is  kelvins.
Answers: 2
question
Chemistry, 22.06.2019 05:50
Astudent made a graph plotting the progress of a reaction over time. the student forgot to label the y-axis of the graph. a graph is shown with two graph lines. one graph line starts at a higher position on the y axis and slopes downwards towards the right. the other graph line starts at a lower position on the y axis and slopes upwards towards the right. the two graph lines stop short of intersecting each other and continue as separate lines which gradually become straight and parallel to the x axis. a vertical line is shown at a point where the two graph lines finally became parallel to the x axis. this vertical line is labeled equilibrium. the title on the x axis is time and an arrow pointing towards the right is shown above time. the title on the y axis is left blank. what best explains the label that the student should use on the y-axis? amount, because as the amount of product decreases, the amount of reactant increases over time. reaction rate, because forward and backward reaction become equal at equilibrium. amount, because the amounts of reactants and products become constant after equilibrium is reached. reaction rate, as the rate of forward reaction increases and rate of backward reaction decreases over time.
Answers: 3
question
Chemistry, 22.06.2019 09:10
When a nucleus absorbs a neutron and then breaks apart, there are many products of the reaction. what is not a product of a nuclear fission reaction
Answers: 1
question
Chemistry, 22.06.2019 10:00
Nonpoint source pollution is difficult to control because it
Answers: 2
You know the right answer?
1. Stirring increases the rate of solution
by increasing the rate of between
the solvent...
Questions