subject
Business, 27.02.2020 05:56 milkshakegrande101

Which of the following is true? A. The supply-and-demand model is appropriate for analysis under certain conditions. B. The supply-and-demand model always applies in goods markets, but only sometimes applies in service markets. C. The supply-and-demand model is always appropriate for analysis. D. The supply-and-demand model always applies in service markets, but only sometimes applies in goods markets.

ansver
Answers: 1

Another question on Business

question
Business, 21.06.2019 19:20
Which of the following accurately describes a surplus? a. consumer demand for a certain car is below the number of cars that are produced. b. the production costs for a certain car are below the sale price of that car. c. a reduction in the cost of steel enables a car company to reduce the sale price of its cars. d. a car company tries to charge too high a price for a car and has to reduce the price. 2b2t
Answers: 1
question
Business, 21.06.2019 20:20
Aproduction order quantity problem has a daily demand rate = 10 and a daily production rate = 50. the production order quantity for this problem is approximately 612 units. what is the average inventory for this problem?
Answers: 1
question
Business, 22.06.2019 03:10
Jackson is preparing for his hearing before the federal communications commission (fcc) involving a complaint that was filed against him by the fcc regarding the interruption of radio frequency. the order to "cease and desist" using the radio frequency has had a detrimental impact on his business. once the administrative law judge prepares his or her initial order, jackson has no further options. no, jackson can request that the matter be reviewed by an agency board or commission. yes, once the initial order is presented, it's only a matter of time before the order becomes final.
Answers: 3
question
Business, 22.06.2019 12:50
Performance bicycle company makes steel and titanium handle bars for bicycles. it requires approximately 1 hour of labor to make one handle bar of either type. during the most recent accounting period, barr company made 7,700 steel bars and 2,300 titanium bars. setup costs amounted to $35,000. one batch of each type of bar was run each month. if a single company-wide overhead rate based on direct labor hours is used to allocate overhead costs to the two products, the amount of setup cost assigned to the steel bars will be:
Answers: 2
You know the right answer?
Which of the following is true? A. The supply-and-demand model is appropriate for analysis under cer...
Questions
question
Biology, 17.11.2019 18:31
question
English, 17.11.2019 18:31
question
History, 17.11.2019 18:31
question
Mathematics, 17.11.2019 18:31
question
Mathematics, 17.11.2019 18:31