subject
Business, 03.12.2019 04:31 jason9394

Kinsi corporation manufactures three different products. all five of these products must pass through a stamping machine in its fabrication department. this machine is kinsi's constrained resource. kinsi would make the most profit if it produces the product that:

a. uses the lowest number of stamping machine hours.
b. generates the highest contribution margin per unit.
c. uses the highest number of stamping machine hours.
d. generates the highest contribution margin per stamping machine hour.

ansver
Answers: 1

Another question on Business

question
Business, 22.06.2019 01:30
If a firm plans to issue new stock, flotation costs (investment bankers' fees) should not be ignored. there are two approaches to use to account for flotation costs. the first approach is to add the sum of flotation costs for the debt, preferred, and common stock and add them to the initial investment cost. because the investment cost is increased, the project's expected return is reduced so it may not meet the firm's hurdle rate for acceptance of the project. the second approach involves adjusting the cost of common equity as follows: . the difference between the flotation-adjusted cost of equity and the cost of equity calculated without the flotation adjustment represents the flotation cost adjustment. quantitative problem: barton industries expects next year's annual dividend, d1, to be $1.90 and it expects dividends to grow at a constant rate g = 4.3%. the firm's current common stock price, p0, is $22.00. if it needs to issue new common stock, the firm will encounter a 6% flotation cost, f. assume that the cost of equity calculated without the flotation adjustment is 12% and the cost of old common equity is 11.5%. what is the flotation cost adjustment that must be added to its cost of retaine
Answers: 1
question
Business, 22.06.2019 06:00
For 2018, rahal's auto parts estimates bad debt expense at 1% of credit sales. the company reported accounts receivable and an allowance for uncollectible accounts of $86,500 and $2,100, respectively, at december 31, 2017. during 2018, rahal's credit sales and collections were $404,000 and $408,000, respectively, and $2,340 in accounts receivable were written off.rahal's accounts receivable at december 31, 2018, are:
Answers: 2
question
Business, 22.06.2019 06:20
About time delivery co. incurred the following costs related to trucks and vans used in operating its delivery service: classify each of the costs as a capital expenditure or a revenue expenditure. 1. changed the oil and greased the joints of all the trucks and vans. 2. changed the radiator fluid on a truck that had been in service for the past four years. 3. installed a hydraulic lift to a van. 4. installed security systems on four of the newer trucks. 5. overhaul the engine on one of the trucks purchased three years ago. 6. rebuilt the transmission on one of the vans that had been driven 40,000 miles. the van was no longer under warranty. 7. removed a two-way radio from one of the trucks and installed a new radio with a greater range of communication. 8. repaired a flat tire on one of the vans. 9. replaced a truck's suspension system with a new suspension system that allows for the delivery of heavier loads. 10. tinted the back and side windows of one of the vans to discourage theft of contents.
Answers: 1
question
Business, 22.06.2019 13:50
Diamond motor car company produces some of the most luxurious and expensive cars in the world. typically, only a single dealership is authorized to sell its cars in certain major cities. in less populous areas, diamond authorizes a single dealer for an entire state or region. the manufacturer of diamond automobiles is using a(n) distribution strategy for its product.
Answers: 2
You know the right answer?
Kinsi corporation manufactures three different products. all five of these products must pass throug...
Questions