Understand the relationship between resistance and conductors.

The resistance of a given object depends primarily on two factors: What material it is made of, and its shape. For a given material, the resistance is inversely proportional to the cross-sectional area; for example, a thick copper wire has lower resistance than an otherwise-identical thin copper wire. Also, for a given material, the resistance is proportional to the length; for example, a long copper wire has higher resistance than an otherwise-identical short copper wire. The resistance R and conductance G of a conductor of uniform cross section, therefore, can be computed as

where is the length of the conductor, measured in metres [m], A is the cross-sectional area of the conductor measured in square metres [m²], σ (sigma) is the electrical conductivity measured in siemens per meter (S·m−1), and ρ (rho) is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω·m). The resistivity and conductivity are proportionality constants, and therefore depend only on the material the wire is made of, not the geometry of the wire. Resistivity and conductivity are reciprocals: . Resistivity is a measure of the material's ability to oppose electric current.

This formula is not exact, as it assumes the current density is totally uniform in the conductor, which is not always true in practical situations. However, this formula still provides a good approximation for long thin conductors such as wires.

Another situation for which this formula is not exact is with alternating current (AC), because the skin effect inhibits current flow near the center of the conductor. For this reason, the geometrical cross-section is different from the effective cross-section in which current actually flows, so resistance is higher than expected. Similarly, if two conductors near each other carry AC current, their resistances increase due to the proximity effect. At commercial power frequency, these effects are significant for large conductors carrying large currents, such as busbars in an electrical substation,[3] or large power cables carrying more than a few hundred amperes.

an individual’s sex (i.e., whether they are a male or female) is determined by the sex chromosomes. most people have two sex chromosomes, one that is inherited from their mother and one that is inherited from their father. typically, females have two x chromosomes (xx) and males have one x chromosome and one y chromosome (xy). conditions caused by changes (“mutations”) in genes located on the x chromosome are considered x-linked.

x-linked recessive inheritance

most x-linked conditions are recessive. this means that in a person with two x chromosomes (most females), both copies of a gene (i.e., one on each x chromosome) must have a change or mutation whereas in a person with one x chromosome (most males), only one copy of a gene must have a mutation. a female with a mutation in one copy of a gene on the x chromosome is said to be a “carrier” for an x-linked condition. a male with a mutation in a gene on the x chromosome is typically affected with the condition. because females have two copies of the x chromosome and males have only one x chromosome, x-linked recessive diseases are more common among males than females. however, x-linked recessive diseases can occur in both males and females.

for x-linked recessive disorders, an unaffected carrier mother who has a mutation in a gene on the x chromosome can transmit either the x chromosome with this mutation or a “normal” x chromosome to her children. if the father is unaffected, none of her daughters will be affected and all of her daughters will be unaffected—since they will inherit at least one normal x chromosome from their father. however, each daughter will have a 50% chance of being an unaffected carrier like her mother and a 50% chance of both x chromosomes being normal.